Where to Buy
Service & Support
e-Learning
Weld Talk
|
#1
|
||||
|
||||
|
Bye, Bye, Bugatti!
__________________
"Good Enough Never Is"
Last edited by Hotfoot; 07-31-2007 at 12:27 AM.. |
|
#2
|
|||
|
|||
|
__________________
Miller 251 w/spoolgun, Lincoln PrecisionTig 275, Miller DialArc 250 AC/DC, Hypertherm 900, Bridgeport J-head, Jet 14" lathe, South Bend 9" lathe, Hossfeld bender, Logan shaper and an Ellis 3000 bandsaw. |
|
#3
|
|||
|
|||
|
#4
|
||||
|
||||
|
__________________
"Good Enough Never Is"
Last edited by Hotfoot; 07-31-2007 at 05:18 PM.. |
|
#5
|
|||
|
|||
|
#6
|
||||
|
||||
|
__________________
Jim Young www.jimyo.com |
|
#7
|
||||
|
||||
|
__________________
It's only a mistake if you don't learn from it!!!!! Wrenchbender Miller 250 Buzz Miller Trail Blazer 301 Meco Weld master Very old smith smoke axe Hobart 400 DC portable Hobart porta feed 17 and a lot O' udder stuff |
|
#8
|
||||
|
||||
|
__________________
I NEED MORE COWBELL!!! 'Red' Powcon 300ST (no torch yet) (ok, not really a 'Red'... )'Blue' Miller 35 (older than me and runs great), Thunderbolt AC arc (ditto) 'Craftsman' AC arc (who made this originally?) O/A x 2 (both smaller than I'd like) 14" Milwaukee chopper 20t HF press (crap, but works) Buffalo forge w/ blower Alot of pumps! "All of us know more than any of us."- TexHand |
|
#9
|
||||
|
||||
|
__________________
"Good Enough Never Is"
|
|
#10
|
||||
|
||||
|
__________________
--- RJL ---------------------------------------------- Ordinarily I'm insane, but I have lucid moments when I'm merely stupid. ------------------------- DialArc 250 SyncroWave 250 SP-175+ Victor O/A 1200 sq.ft. of garage filled with crap A kid that can actually run the stuff +++ |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|