Does anyone have any "hands on" with Incoloy on Incol (not sure of the spelling, material has INCOLOY paint pened on it.) I am unfamiliar with this material. Would appreciate it if anyone has any advice as to tensil, tig rod type, or other special procedures to follow in fab/welding. The jist: 3"x3/4" flat bar, want to cut/drill and butt weld on ends of Ibeams for concrete anchors. All loads in z axis, no bending moments. Was suggested a hard but brittle stainless that might let go of weld bead over time.
"If at first you don't succeed, keep on sukin till you do succeed." Curly Howard.
Where to Buy
Service & Support