1.25" sched. 40 rail I just finished up. It's been a while since i've poked my head around here. Happy New Year!
![]()
Where to Buy
Service & Support
e-Learning
Weld Talk
1.25" sched. 40 rail I just finished up. It's been a while since i've poked my head around here. Happy New Year!
![]()
Nice job! Did you build it in place? I see several challenges there.
Arcin' and sparkin', Rocky D <><![]()
Experience is something you don't get until just after you need it.
IF YOU CAN READ THIS, THANK A TEACHER...
IF YOU'RE READING THIS IN ENGLISH, THANK A SOLDIER!
yup built on site. it was a bot tricky in places but it came out great.
Just digging post holes could be tricky.
Roger
the ground is so hard and so full of rocks there! sched. 40 comes in 21' lengths so I placed the posts every 7'. it took about 10 hours once the posts were set.
How deep did you set the posts?
It looks like you could have gone a little shallow having the whole thing tied together end to end like you do, but I wonder.
Thanks
the terminal posts are ~ 30" and the line posts are 22-24".
I like it. Whereabouts are you? I see a little snow.
--- RJL ----------------------------------------------
Ordinarily I'm insane, but I have lucid moments when I'm merely stupid.
-------------------------
DialArc 250
SyncroWave 250 w/Coolmate 3
SP-175+
TA 161STL
Lincwelder AC180C circa 1950
Victor & Smith's O/A
Dayton (Miller) spot welder
1200 sq.ft. of garage filled with crap
A kid that can actually run the stuff +++
This house is in Santa Fe, NM. I live in Rio Rancho, NM about 40 miles away. Supposed to be 50 deg today!
Never been to New Mexico. With all the rock in the soil you should have a good, firm footing.
it was a huge pain in the @ss digging the post holes! too many rocks!