Hobart Welders
Home » Weld Talk
Weld Talk Message Boards - Powered by vBulletin
Results 1 to 2 of 2
  1. 08-16-2011, 06:45 AM #1
    ptsideshow's Avatar
    ptsideshow
    ptsideshow is offline Senior Member
    Join Date
    Jan 2006
    Location
    Mount Clemens Mich
    Posts
    916

    Loader bucket cutting edge?

    Does anybody know what kind of steel the Loader bucket cutting edges are made from. somebody called me and asked as they want to make some tools/tooling out of it. A general type if any one knows? thanks
    glen, been there, done that and probably broke it!If you aren't on the edge. You'r taking up to much room
    Reply With Quote Reply With Quote
  2. 08-16-2011, 09:43 AM #2
    usmcpop's Avatar
    usmcpop
    usmcpop is offline Senior Member
    Join Date
    May 2005
    Location
    Richmond, Virginia
    Posts
    5,315
    A few possibilities:

    http://www.conmecheng.co.uk/en/products.asp
    --- RJL ----------------------------------------------

    Ordinarily I'm insane, but I have lucid moments when I'm merely stupid.
    -------------------------
    DialArc 250
    SyncroWave 250 w/Coolmate 3
    SP-175+
    TA 161STL
    Lincwelder AC180C circa 1950
    Victor & Smith's O/A
    Dayton (Miller) spot welder
    1200 sq.ft. of garage filled with crap
    A kid that can actually run the stuff +++
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules