Hobart G-213 Wire diagram

[Danbou]

Hi,

Can you help me to find a free Hobart G-213 Generator/welder wiring diagram.

Thanks.

Danbou

[old fart]

Found one! PM me an Email to send it to .
Regards O.F.

[Danbou]

Found one! PM me an Email to send it to .
Regards O.F.

Hi,

Thank you very much for your help.

My e-mail address is danbou02@videotron.ca

Best regards!

Danbou

[martinf]

Found one! PM me an Email to send it to .
Regards O.F.

Hey Old fart,
COuld you email me that manual, too? Ive got one of those old G-213's (mine's powered by a Wisconsin 4 cyl) and all of a suden, today, it just stopped putting out amps. Nothing. No 40 volts, no nothing. I gotta figure it out and have no wiring diagram to consult. If you could send me a wiring diagram, I'd sure appreciate it.
You can send it to martinf@forkidsake.net

Thanks a lot.
~martin

[martinf]

Boy,
was I wrong...it's not a G-213, it's a Spec 514 Hobart Simplified, built in June 1941 (Thanks, Keith). SUrpirisingly, it all workes well...well, it did last Fall, but now this SPring, egine started right up, bu no juice coming to the leads on the welder. Not even a volt! I've included a pic of it

Two questions for you guys:
1 - Does anybody have a wiring diagram for this old girl?
And 2 - How do I flash the shunt on this one? I tired just hooking 12 v up to the output (stinger and ground) for a few seconds, but I'm guessing that's not the right way. How do I isolate the shunt windings and does it matter which way I hook them up, polarity wise?

thanks for any assistance.
~martin

[divedigger]

Found one! PM me an Email to send it to .
Regards O.F.

Would you also email a wireing diagrahm for a g213? I would greatly appreaciate it and pay you if needed. Thanks Steve
Douglas dozerdouglas@embarqmail.com

[Delano_man]

If any of you guys have a chance to send it to my email address, it would be much appreciated. Thanks!

Delano_man@hotmail.com

[bradsmokes]

sounds good to me

[benny2000]

Found one! PM me an Email to send it to .
Regards O.F.

Hi Old Fart. (love the nickname)

Just wondering if you still have that manual for the Hobart G213? Would be most grateful if you could email it to me at benny2000@bigpond.com

I just got hold of one of these and am having the same problem as some other folks, welding works fine, but no AC output.

Thanks in advance for your help.

Cheers, Ben.

[smitty13]

could you please send me the wiring diagram also, and a manual if you have it. thanks sean

[smitty13]

email sean.d.a.smith@gmail.com

[jsharrits]

What would it take to get a manual and or a wiring diagram also?
Thank you
Jeff
jjsharrits@aol.com

[DaveC]

I just bought on of these off of craigslist that ran, but has AC voltage issues. Could someone email me one of those wiring diagrams for the G-213, SPEC 5776-1 (Wisconsin TJD w/ magneto).
Thanks,
DaveC

[Gidderdone]

My G213 has crank start, I think it will start itself,I would like to know how to connect battery or batteries, there is no existing cables so I am not sure where the cables would go. Thanks for any help.