Hobart Welders
Home » Weld Talk
Weld Talk Message Boards - Powered by vBulletin
Results 1 to 2 of 2
  1. 09-24-2008, 04:06 PM #1
    B_C's Avatar
    B_C
    B_C is offline Senior Member
    Join Date
    Jun 2008
    Location
    Martinez CA
    Posts
    1,572

    under water plumbing

    I got a call yesterday from one of my mom pop machine shop accounts.....This is what they had for me to weld up













    Some people require more attention than others.....Like a LOST DOG and strangers holding out biscuits....

    Dynasty 350
    Hobart Beta Mig 200
    Twenty seven Hammers
    Three Crow Bars
    Two English Springer Dogs



    A Big Rock
    Reply With Quote Reply With Quote
  2. 09-24-2008, 04:11 PM #2
    B_C's Avatar
    B_C
    B_C is offline Senior Member
    Join Date
    Jun 2008
    Location
    Martinez CA
    Posts
    1,572
    They cut a weld prep in the flange
    too wide so I had to run a bead around the hole and fill it up a bit..
    The customer was afraid that there would be too much heat on the joint....
    I did what they said even though I don't think there would have been a problem (I purged the tube) Oh and yes I have people hanging out at my shop all the time....This guy is one of my
    bigger friends...6' 5" 310 lbs sheet rocker....
    Last edited by B_C; 09-24-2008 at 04:14 PM.
    Some people require more attention than others.....Like a LOST DOG and strangers holding out biscuits....

    Dynasty 350
    Hobart Beta Mig 200
    Twenty seven Hammers
    Three Crow Bars
    Two English Springer Dogs



    A Big Rock
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules