welder problems,PLEASE HELP!

[nuweld]

have a miller cp-250ts mig and s-52e wire feeder.
The power comes on and wire feeds but not getting any power to teminals.
is wired for 230 3 phase getting power to jumper pannel.
no reading on volt or amp meters.
PLEASE HELP!!
Have already gone through the trouble shooting without any luck.

[trial&error]

have you tried to weld?? most units have no voltage or current until you pull the trigger and start welding.

[nuweld]

Yes.......... nothing!

[Noisy Nova]

I'm not familiar with your specific equipment, but, the wire feeder trigger not only starts the feed motor, but also closes a relay that sends a signal to your power supply. This signal will operate another contactor that will energize the output terminals. Check your service manuals for the wiring connections.

[nuweld]

It turned out to be wired wrong in the control connector. bought it used and someone didn't know what they were doing to get right.
THANKS FOR THE HELP!!!!!!!!