Hey what's goin on everyone. I'm new to this board and welding in general so I have some questions. I recently bought a wire feed MIG welder that uses flux cored wire. It doesn't have a hook up or anything for gas. I was wondering if it's possible for me to weld aluminum with this. Does anyone make aluminum flux cored wire that I could use? I'm majoring in Weding Engineering at Ohio State University but I haven't gotten into my core classes yet, so the only stuff I know about welding I've just learned from reading welding books and web sites for fun. I've always been intrigued by welding and I definitely would like to become certified some day. I just bought the welder because I know that the only way I'll learn is by doing, so I might as well just start and keep doing. But I am getting into doing some metalforming with aluminum, and I was just wondering whether there is a way to weld it with this machine without a gas setup. Any ideas? Thanks.
Where to Buy
Service & Support