Need help finding Airco Manual

[Kent]

I picked up a old Airco 300 this weekend. I have used tig machines years ago, but didn't ever pay much attention to how they were hooked up, and there was always someone there to help me get the controls set right. Anyone know where I might be able to find a owners manual for a Airco?

It only came with the torch, so I need to find a foot control, and a water circulator, and of course a tank and guage.

I have been pricing out some of it on the web, but if possible I wouldn't mind going used to save some money. Anyone have any good sites to look for used stuff besides Ebay? Has anyone built their own water circulator? If so, care to share the best way to do it?

Thanks for any suggestions or help.

[vicegrip]

Only I have two to put gear on...I can help you with general hook-up and
practice....I have to find out what resistance peddle to use yet...and if you can't just run soft city water through to a floor drain...you can easily make a fully
fuctional chiller from a used dehumidifier...a 1/3 hp motor and a $65 pump
from Procon mfg.(spelling ???)....an argon tank and arangement is going to
mean some $$...shop around first...I'm tripple booked during the week...so
have patience... E-mail is 737373@sbcglobal.net
Phil J.