The Dynasty 200DX came last Friday from B&R Welders via UPS with no external damage to the box and I need some help wiring it up.
We don’t expect to be in this house by next summer so I would like to do the ol "hook it to the dryer plug in the garage" routine. I don’t think I'll be pushing the machine to the max but somewhere I read the Dynasty 200 only needs a thirty-amp breaker anyways. That being said I don’t want to burn down the house by doing this either so is this safe?
Ok the red wire on the Dynasty is for three phase so cut it short, put a heat shrink tube over it and wire it back away from the other wires…done. Now for the other three Dynasty wires green, white and black, that is where I need some help.
Here is a shot of the breaker box. The dryer comes off the double breaker with the black arrow. Those two breakers are in the off position and are each labeled 30.
Here is a shot of the dryer plug
Here is a shot of the backside of the dryer plug’s three wires red, black and white.
Here is a shot of the front of the dryer plug with each wire labeled red (R), black (B) and white (W).
I assume the white wire on the dryer is the ground and the green wire on the Dynasty goes to that white terminal….yes?
Now the next two wires on the Dynasty are black and white:
The dryer’s red wire goes to the Dynasty’s ______ wire.
The dryer’s black wire goes to the Dynasty’s _____ wire.
Thanks for your help!
Where to Buy
Service & Support