Need schematics for old Hobart

[Joshpm18]

I have an old hobart flex wire, model #gcc-510, serial #24dw-2664 it has the chrysler slant six on it. The engine runs but the wiring is shot. HELP ME HOBART BILL!!!!!!!!!!!!!!!!

[old fart]

I have the drawings but the file is too big to upload on the forum. I could Email then to you if you wish.

Note to modrator. A quick lesson on how to attach larger files to the forum would be helpful. 100Kb I believe is less than 1/2 a page of print! Or am I completly off base on this?
Regards O.F.

[Hobart Expert Bill]

The unit is a multi-process machine CC/CV, 500 A 60% duty cycle.
Mfg date 5/31/72
Spec # 5294A
Originally sold to National Southwire Aluminum, Hawesville, KY

Call the tech service group at 800-332-3281. We can provide the complete manual in pdf it is 6.5 MB.

[Joshpm18]

Lots of thanks, guys. You can e-mail me the drawings at
josh_morris55@yahoo.com
Hopefully this will look good mounted in the back of my 1956 International ton truck.

[bwldng]

Lots of thanks, guys. You can e-mail me the drawings at
josh_morris55@yahoo.com
Hopefully this will look good mounted in the back of my 1956 International ton truck.

Send a photo if you can.Sounds like a cool rig! You might want to invest in new rear springs to hold up that hefty welder! Good luck.

[Joshpm18]

Thanks again for the info and the manual. I'll be welding in no time now.!!