Missing Parts on Hobart Airforce 400

[Mike Ault]

It appears there were store termites at my local Tractor Supply Co. where I just purchased the above cutter. TSC displays their products instead of keeping them in boxes. I think someone kyped some nozzle parts.

Being unfamiliar with the intracacies of plasma cutter parts, I was wondering if anywhere on this site there may be a good exploded view of the parts that are "supposed" to be inside the cup.

The manual shows a crude exploded drawing of the parts that are supposed to be there, but I cannot tell what I have and what I don't. I believe I am missing the swirl ring, but the drawing in the manual is less than instructive as to what it looks like.

Any help would be appreciated.

Mike

[84ZMike]

What torch do you have? If it's the ICE 27c/t then there is a good brake down in the parts manual

http://www.hobartwelders.com/service/owners-manuals/

[Broccoli1]

Here is a color exploded view from the Plasma cutter section listed under Products above

http://www.hobartwelders.com/products/accessories/plasma/

[Zrexxer]

The manual shows a crude exploded drawing of the parts that are supposed to be there, but I cannot tell what I have and what I don't. From the manual:

http://www.hobartwelders.com/weldtalk/attachment.php?attachmentid=27275&stc=1&d=1223258821

[Mike Ault]

You all were very helpful. I have the ICE27C and it is clear I am missing the swirl ring.

Thanks to all!

Mike